What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 21.06.2025 04:50

(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
So, the voltage could go up to 500 volts, and the fuse will not open up.
A circuit breaker is similar, but is resettable.
He then describes Rainy Season and Lightning.
This is where the MOV conducts again, and dissipated the energy.
but this device (an Inductor) … impedes the rapid changes in the current.
Why am I sweating so much when I try to do anything?
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
A fuse is a non-resetable over current circuit protector.
At one ohm, the resistor has a maximum of 1 watt power.
One
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
For this case there are devices called Metal oxide varistors (MOV).
An AC voltage/ current source, and an ac inductive load.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
There are two important concepts here.
This is 'the assistant's answer'
These are simplified answers to the original question, and does not change anything I wrote above.
What does a fuse do?
How did Kate Mulgrew feel about Jeri Ryan joining the cast of Star Trek: Voyager?
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
2024–10–14 [Omar Gharbi Omar Gharbi ]
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Has Pope Francis signed a document that gay men can now become priests?
but I think this circuit , shows a few more pieces.
The third is lightning and “how it gets conducted into a home.”
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
How can I fall asleep fast at night?
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
There are three different concepts here that are getting confused.
(Dc diagram shown, AC is similar).
Beef cattle disease found in southeast Iowa herd, first time seen in state - weareiowa.com
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
This is where this question deviates from being a 'generic' question, and becomes more specific.
The bolt then partially travels down the line to your home.
He then asserts :
so, what happens?
What are the causes of over sweating?
Upvotes:
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
the problem then depends on "how fast does the fuse operate?".
What does it mean if someone asks if it’s pink?
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Edit 2024–10.
First Sentence:
Why in my 60s do I have a strong desire to suck cock and swallow?
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
What is lightning?
This is the picture of an electronic coil of wire wound around a core of magnetic material.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
a photo is worth a thousand words.
Because the load is inductive, the current lags the voltage.(by a bit).
This one hit behind the barn.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
But it can get overloaded, and no longer works.
At least they know the answer if they wanted it.
2024–10–10[John johnson John Johnson ]
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
The MOV will conduct when the voltage exceeds 50% of line voltage.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Now when you have a certain ac resistance, then a current flows in a loop.
Barnstars:
One is “what exactly is in a ‘surge protector’ ? ”
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
In schematic diagrams this is the symbol for a fuse:
what exactly is a ‘surge’ protector?
eight
[old diagram got deleted by accident]
He then describes the function of a fuse.
It seems Mohan does not understand the difference between a comment and an Answer.
Here is a simplified AC power diagram.
These devices are installed between the “hot” and “neutral” and protective ground.
I post the exact comment here.
The other is “what does a “fuse” do?”
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
[image of Common-mode choke]
But… the neutral is now “floating” because of the 1 ohm resistance.
2024–10–16 [ OO OLAOYE OYEBODE ]
It also is a device that limits the change in current flow.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
nine
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
This device then solves the entire problem.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.